Construction of equipment for abrasive wear according to ASTM G-65 standard
DOI:
https://doi.org/10.22517/23447214.9327Keywords:
Desgaste abrasivo, Norma ASTM G-65, tribología.Abstract
This work shows the construction and fine tuning of equipment for abrasive wear tests with dry sand rubber wheel "DSRW", according to ASTM G-65. Initially equipment components are described, some of which were purchased commercially and others were built. Subsequently the calibration of next variables was performed: diameter and hardness rubber coating, grain size, moisture and abrasive flow, motor speed and force applied to the specimen. Validation of equipment operation is then performed according to procedure B, using different types of material: gray iron, bronze and nickel-based coatings (Metaceram 23075 and Nitec 10224), repeatability presenting the results for each material. By applying statistical methods, the coefficient of variation was determined, which was below the maximum limit allowed in the standard (6%). Finally, the analysis of wear scars by scanning electron microscopy is performed, being wear mechanism typical of ductile and fragile materials.Downloads
Downloads
-
Vistas(Views): 506
- PDF (Español (España)) Descargas(Downloads): 610
Published
How to Cite
Issue
Section
License
Copyrights
The journal is free open access. The papers are published under the Creative Commons Attribution / Attribution-NonCommercial-NoDerivatives 4.0 International - CC BY-NC-ND 4.0 license. For this reason, the author or authors of a manuscript accepted for publication will yield all the economic rights to the Universidad Tecnológica of Pereira free of charge, taking into account the following:
In the event that the submitted manuscript is accepted for publication, the authors must grant permission to the journal, in unlimited time, to reproduce, to edit, distribute, exhibit and publish anywhere, either by means printed, electronic, databases, repositories, optical discs, Internet or any other required medium. In all cases, the journal preserves the obligation to respect, the moral rights of the authors, contained in article 30 of Law 23 of 1982 of the Government Colombian.
The transferors using ASSIGNMENT OF PATRIMONIAL RIGHTS letter declare that all the material that is part of the article is entirely free of copyright. Therefore, the authors are responsible for any litigation or related claim to intellectual property rights. They exonerate of all responsibility to the Universidad Tecnológica of Pereira (publishing entity) and the Scientia et Technica journal. Likewise, the authors accept that the work presented will be distributed in free open access, safeguarding copyright under the Creative Commons Attribution / Recognition-NonCommercial-NoDerivatives 4.0 International - https://creativecommons.org/licenses/by-nc-nd/4.0/deed.es license.